Technical data

16 312013
Operation
Setup Mode
The Setup Mode is used to set parameters for monitoring fluid flow with the Informer display. Setup parameters are
described on page 17.
To enter Setup Mode, hold down the enter button
, then press the up arrow button . While in Setup Mode, the
same button sequence will exit Setup Mode.
Setup Mode is represented by a letter and number on
the left side of the display, which indicate the current
setup parameter. Setup Mode starts with the A1 (Batch
Totalizer Units).
cc
Batch Totalizer Units Setup Screen
Button Functions in Setup Mode
The function of the buttons in Setup Mode varies, depending on which parameter is being set. See the table below
for the basic function of the buttons while in Setup Mode. See page 17 for a description of each setup parameter
and how to configure them.
NOTE: When setting parameters, the value selected for editing will flash.
Button
Function
Enter and Advance to the Next Parameter:
Use the enter button to enter the current value selected (flashing) and advance to the next
setup parameter.
Scrolling Through Fields:
Use the down arrow button to go to the next field of the current setup parameter.
Field: Each of the following numbers is in a separate field: 0 5 . 5
Scrolling Through Selections:
Use the up arrow button to scroll through the valid selections of the current setup parameter.
Valid Selections: 0 to 9 are valid selections for number fields. L, cc, gal, and oz are
valid selections for units.
Reset Value to Zero:
Press the reset button to zero the entire numerical value.
Exit Setup Mode:
Hold down the enter button, then press the up arrow button to exit Setup Mode.