Technical data

4 312013
Warnings
The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The exclama-
tion point symbol alerts you to a general warning and the hazard symbol refers to procedure–specific risk. Refer
back to these warnings. Additional, product–specific warnings may be found throughout the body of this manual
where applicable.
WARNING
SKIN INJECTION HAZARD
Spray from leaks, or ruptured components can inject fluid into your body and cause extremely serious
injury, including the need for amputation. Splashing fluid in the eyes or on the skin can also cause
serious injury.
D Fluid injected into the skin might look like just a cut, but it is a serious injury. Get immediate surgi-
cal treatment.
D Do not stop or deflect fluid leaks with your hand, body, glove, or rag.
D Follow the Pressure Relief Procedure on page 13 whenever you: are instructed to relieve pres-
sure; stop operation; or clean, check, or service the equipment.
D Tighten all the fluid connections before operating the equipment.
D Check the hoses, tubes, and couplings daily. Replace worn, damaged, or loose parts immediately.
FIRE, EXPLOSION, AND ELECTRIC SHOCK HAZARD
Improper grounding, poor air ventilation, open flames, or sparks can cause a hazardous condition and
result in fire or explosion and serious injury.
D Ground the equipment as instructed in Grounding, page 13.
D Never use the flow meter with an electrostatic gun isolation stand.
D Keep liquids away from the electronic sensor device.
D Follow the material supplier recommendations when flushing or servicing the meter.
D Do not service the electronic sensor. Return it to your Graco distributor for service.
D If there is any static sparking while using the equipment, stop spraying immediately. Identify and
correct the problem.
D Keep a fire extinguisher in the work area.