Use and Care Manual
Barbecue Grills
LTR50001038, Rev. B
Appendix
www. ca l a me b bq . c o m
25
All Cal Flame grills are manufactured as standard
liquid propane (LP) grills and can be converted to
burn natural gas (NG). There are two steps required
to convert a grill from LP to NG.
You must perform both steps.
Step 1: Switching the regulator behind the
grill
Step2: Changingtheburnerorices
The conversion kit provided with your grill may in-
clude some or all of the parts shown at right, de-
pending on the size and model of your grill.
The kit contains orices to convert main burners,
rear infrared burners, and the large infrared burner.
Your kit will have only the parts you need to convert
your grill.
Before you begin, make certain the LP gas source
has been disconnected from the grill.
To gain access to the NG regulator, tilt the grill for-
ward.
Step 1: Switching the regulator be-
hind the grill
The manifold in the image below has been removed from a grill to illus-
trate this procedure.
Remove the LP gas line.1.
Remove the cap tting from the end of the NG gas regulator.2.
Place the cap tting over the LP gas inlet.3.
Insert a male ared tting (4. not provided) in the NG gas regulator.
Converting from LP to NG
WARNING! You must have an authorized service technician perform this pro-
cedure. Ifthese instructions arenot followed exactly,a re orexplosion may re-
sult causing property damage, personal injury or loss of life. Lloyd’s Material Supply
(L.M.S.) will not be held responsible for an improperly converted gas grill.
You will need:
13mm open end wrench•
Male ared tting •
(not provided)
Pipe compound suitable •
for natural gas
NOTE:AaredttingisNOTincluded
with your grill.
If you are attaching a ex hose to the regulator,
you will need a tting. The tting requires a male
are on the input end with a 1/2” MPT on the out-
put end. The ared male input end needs to be the
size of your ex tubing. You can also connect the
regulator directly to your NG gas service, which will
not require a ared tting.