Service manual

226
SEP 2006
Ver. 1.1
DP-8020E/8020P/8016P
• i-ADF / ADF Area
J95 The paper size of a Tray differs from the Machine setting size. B
J97 After passing the Registration Sensor (Roller), the Paper does not clear the sensor
within a predetermined time period.
J98 No VRDY Signal after a predetermined time has lapsed.
J99 No VSYNC Signal within a predetermined time after VRDY Signal is activated.
Jam Error Codes (J Code) Table
Code Contents Section
J70 The Read Point Sensor does not detect paper within a predetermined time after the
original starts feeding.
A
J71 The Read Point Sensor keeps detecting paper within a predetermined time after
scanning starts.
J72 The Eject Sensor does not detect paper within a predetermined time after the Read
Point Sensor is activated.
A
(i-ADF
only)
J73 1. The Eject Sensor keeps detecting paper within a predetermined time after
scanning starts.
2. The Eject Sensor keeps detecting paper within a predetermined time after the
Read Point Sensor is deactivated.
J76 The Duplex Eject Sensor does not detect paper within a predetermined time after
scanning starts.
J78 The Duplex Eject Sensor keeps detecting paper within a predetermined time after
2-Sided Scanning.
J79 The Read Point Sensor keeps detecting paper in the ADF. A
J92 The Read Point Sensor does not detect paper in the ADF.
J93 The paper remained in the ADF.
J94 The ADF does not go off after the predetermined time.
Unexpected Jam timing (i.e. Original is too short, Ledger / A3 size original is fed
without being recognized that the length is abnormal for a Fax Transmission, etc.)
Jam Error Codes (J Code) Table
Code Contents Section