Service manual

231
SEP 2006
Ver. 1.1
DP-8020E/8020P/8016P
4.7. Information Codes Table (For Facsimile)
Fax Information Codes
Code Mode Phase Description of Problem Possible Cause(s)
012 RCV C, D The length of the received
document is over 2 m.
030 XMT B Read Point Sensor does not
activate within 10 seconds after
the document starts feeding.
Document not set properly.
Defective Read Point Sensor.
031 XMT
COPY
C Transmitting document was longer
than 2,000 mm (78.7 in).
(Super Fine: 1,000 mm (39.4 in),
600 dpi: 430 mm (16.2 in))
Document may be jammed.
Defective Read Point Sensor.
061 - A ADF Door is open. Cover not firmly closed.
Connectors not firmly connected.
200 RCV C Decoding process did not
complete at the end of phase C.
Defective FXB PCB.
212 XMT
RCV
A-E Interface error occurred between
the CPU, and modem.
Modem defective. (FXB PCB)
Software problem occurred. (SC PCB)
301 XMT
RCV
System fault. Software problem occurred. (SC PCB)
331 XMT C 8-minutes timer error.
(Germany only)
400 XMT B T1 timer (35±5 sec) elapsed
without detecting 300 bps signal.
Wrong number dialed, and the START
button was pushed.
Telephone line disconnected while
dialing.
FXB PCB (Modem), or MJR PCB
defective.
Receiver defective. (It may only be
transmitting CED)
401 XMT B DCN was returned from receiver
while transmitter is waiting for
CFR, or FTT.
Your machine's ID Number is not
programmed.
Possible incompatibility, or incorrect
Password (Password Reception,
Selective Receive).
Mailbox full.
402 XMT B DCN was returned from receiver
while transmitter is waiting for
NSF/DIS.
Receiver working in non-CCITT mode
only. (Possible incompatibility)
403 RCV
(Polling)
B Transmitter had no polling
function.
"POLLED=ON" (polling XMT ready) not
set at the transmitter.
Document to be transmitted not placed
at the transmitter.
404 XMT B Transmitter sent NSS (or DCS)
followed by TCF three times, but
the receiver did not respond.
(CFR, or FTT is usually returned)
Receiver defective. (Modem, MJR PCB,
etc.)
FXB PCB, or MJR PCB defective.
Receiver disconnects line during first
NSS (or DCS) transmitted.