Service manual

274
SEP 2006
Ver. 1.1
DP-8020E/8020P/8016P
5.2. Service Modes (For Facsimile)
5.2.1. Fax Service Mode Procedure
1. To enter the Fax Service Mode
a. Press “FAX/EMAIL” key.
b. Press “FUNCTION”, and then “7” keys.
c. Press “MONITOR” four times, then press “*”.
d. Enter the desired code number, or press the “V”, ”/\” arrow keys.
2. To exit the Fax Service Mode
Press “STOP” key.
Note:
The following buttons provide these functions in the Service Mode:
5.2.2. FAX Service Mode Table
The following service modes are provided to assist you in setting operational functions of the unit, and
determining the condition of the unit.
"START": : The new setting value is stored in the machine.
"V” : Scroll the function parameter number down.
"/\ “ : Scroll the function parameter number up.
Service Modes (For Facsimile)
No. Service Mode Description
00 Not Used
01 Function Parameter Setting Allows changes to the function parameters (the home
position, etc.).
02 RAM Edit Mode Factory use only.
03 Print Parameter List / Report Prints the Function Parameter List, Page Memory Test, Printer
Report, All Document File, Protocol Trace, and Toner Order
Form.
04 Modem Tests Generates various binary, tonal, and DTMF signals, by the
modem.
05 Not Used
06 RAM Initialize Initialize RAM, and restore the default value of the function
parameters.
Note: Turn the Power Switch to the OFF, and back to the ON
position to enable the parameter settings.
07 Not Used
08 Check & Call Allows input of information for Service Alert Report,
Maintenance Alert Report, and Toner Order Form.
09 System Maintenance Used for Firmware Update, Firmware Backup, Parameter
Restore, Parameter Backup, Transferring Firmware from the
PC to the Flash Card, and Sending a Received File during a
fatal printer error.