Service manual

275
SEP 2006
Ver. 1.1
DP-8020E/8020P/8016P
5.2.3. Fax Service Mode 1 (Function Parameter Setting)
Use the following procedure to change the function parameters.
Enter the desired code number, and press “START” key.
↓
If you wish to select another code number, scroll the menu with the “V”, ”/\” arrow keys.
↓
Select the desired function code, and press the "START" key.
↓
When the “CLEAR” key is pressed, the selected code input will not be accepted.
↓
Press “STOP” key twice to exit the service mode.
Function Parameter Table
No. Parameter Selections Function
000 Monitor/Tel Dial 1 = Monitor
2 = Tel/Dial
Selects whether the machine starts to TX
automatically during On-Hook dialing.
Monitor : Start to TX after pressing START
TEL/DIAL : Start to TX automatically
001 Alarm Status 1 = Off
2 = Timer
3 = Constant
Selects the No Paper, or No Toner alarm status.
OFF : Alarm is disabled.
Timer : Alarm will shut off after 6 seconds.
Constant : Alarm will not stop until "STOP" is
pressed, or the error is cleared/
corrected.
002 Stop Comm.
JRNL
1 = Off
2 = On
Selects whether the machine prompts to print the
COMM. Journal when the printout condition is set to
INC, and STOP is pressed during communication.
003 Continuous Poll 1 = Off
2 = Stn (Tx only)
3 = Hub (Rx only)
Selects whether the Continuous Polling feature is
enabled.
Stn : Place the document(s) on the ADF, or Platen,
then press the assigned Program Key to
store, or add the documents into a polled file.
(See Note 1)
Hub : When the polling command is initiated, the
machine will continuously poll originals from
the remote stations until it is interrupted by
pressing "STOP".
004 Numeric ID Set 1 = Off (will not accept)
2 = On (accepts)
Selects whether the machine accepts, and allows to
set, or change the Numeric ID.