Service manual

328
SEP 2006
Ver. 1.1
DP-8020E/8020P/8016P
7.3.5. Paper Size setting (Paper Tray) for your customer
1. Press the "Function" key.
2. Select "1: GENERAL SETTINGS", and press the "Set" key.
3. Select "09 KEY OPERATOR MODE", input the 3 Digit Code (default is 000) to enter the Key Operator
Mode, and press the "Set" key.
4. Select the "01 PAPER SIZE", and press the "Set" key.
5. Press "V" or "
/\" arrow keys to select a New Paper Size, and press the "Set" key.
6. Press the "Reset" key, to exit the General Settings Mode.
7.3.5.1. Serial Number Setting for the Maintenance Report
1. Press "Function", "Original Size", and "3" keys sequentially to enter the Service Mode.
2. Press the "9" key to enter the F9 Mode (Unit Maintenance).
3. Press the "Start" key.
4. Press the "5", and the "Set" keys.
5. Input the Machine’s Serial Number, and press the "Set" key.
6. Press the "Stop" key twice.
7. Press "Function", and "Clear" keys simultaneously to exit the Service Mode.
(5) Insert the Toner Bottle into the Hopper Unit.
Align the Toner Bottle Key with the Key
Alignment Channel of the hopper unit. Insert the
Bottle as far as it will go, and turn the Toner
Bottle clockwise until it locks in place. (Bottle's
Green Knob is lined up with the "Locked" symbol
on the label)
Caution:
Do Not install the Toner Bottle before installing
the Process Unit first. If the Toner Bottle is
installed, and turned to the "Locked" position
without the Process Unit, the Toner will spill inside
the machine.
(6) Install the Toner Waste Container.
(7) Close the Front, and the Left Covers.
(8) Load paper into the Paper Tray.
Caution:
Ensure that all shipping tapes, and packing
materials are removed.