Service manual

340
SEP 2006
Ver. 1.1
DP-8020E/8020P/8016P
8.4.2.Installation
Install the Hardware by following the steps below.
CAUTION!
Turn the Power Switch on the Right Side of the machine to the OFF position, and then
unplug the AC Power Cord before beginning installation.
(1) Open the Left Cover.
(2) Remove 2 Silver Screws.
(3) Remove the Left Scanner Cover.
(4) Remove 2 Shoulder Silver Screws.
(5) Remove the Right Scanner Cover.
(6) Remove 2 Silver Screws.
(7) Slightly lift the Control Panel Assembly.
(8) Disconnect the Harness on the PNL1 PC Board
(CN220).
(9) Remove the Control Panel Assembly.
<For DP-1820E/1820P/1520P only>
Follow the steps (10) ~ (12) below.
(10) Release 2 Latch Hooks.
(11) Remove the Panel Sub Cover.