Service manual

369
SEP 2006
Ver. 1.1
DP-8020E/8020P/8016P
(6) Install the i-ADF onto the ADF Mounting
Brackets.
Note:
a. Set the i-ADF in the direction of the arrow.
b. Align the hallmark on the Right Side of the
Hinge Base, and the ADF Mounting Bracket
as illustrated.
(7) Tighten 2 Thumb Screws (M4 x 10).
(8) Install 2 Hinge Cover 2.
(9) Secure the Automatic Document Feeder with 2
Silver Screws (M4 x 10).
(10) Install 1 Screw (M4 x 8) on the back of the left
ADF Mounting Bracket from the bottom as
illustrated.
(11) Remove 10 Screws.
(12) Remove the Rear Cover.
(13) Remove the Protective Sheet.
(14) Bend the Protective Tab on the Rear Cover
approx. 180° towards the inside of the machine
as illustrated.
(15) Connect the i-ADF Harness to CN650 on the
SPC PC Board.
(16) Insert the Harness Clamp into the pre-drilled
hole in the frame (from underneath).
Note:
Do not cut the Harness Clamp (Tie-Wrap) when
servicing. Push the release clip on the side of the
clamp to remove it.