Service manual

370
SEP 2006
Ver. 1.1
DP-8020E/8020P/8016P
(17) Before proceeding, install the other options first.
If finished, close the i-ADF.
(18) Reinstall the Rear Cover.
(19) Secure the Rear Cover with 10 Screws.
(20) Plug the AC Power Cord and turn the Power
Switch on the Right Side of the machine to the
ON position.
(21) Reconnect the Telephone Line Cable if it was
disconnected.
(22) Using a 20 lb (80 g/m
2
) lined original, make a
copy from the ADF to check the feed alignment.
(23) Check the alignment of the Copy Image. If the
Copy Image is skewed either to the Right or Left,
adjust the ADF's alignment as follows:
a. Loosen 5 Screws securing the ADF.
b. Using the Hallmark on the Right Hinge Base
and the ADF Mounting Bracket as a guide,
shift the ADF position by following the
procedure below:
• When the Copy Image is skewed to the right,
shift the ADF slightly toward the front of the
machine.
• When the Copy Image is skewed to the left,
shift the ADF slightly toward the rear of the
machine.
c. Tighten the 5 Screws loosened in step (a).
d. Repeat step (22) to recheck the feed
alignment and readjust the ADF position as
needed.
(24) Install 2 Hinge Stoppers.
(25) Secure 2 Hinge Stoppers with 4 Screws (M4 x
8).
Copy Image Leading Edge
< Example of Printed Image >
Skewed to
the right