Specifications

Installation / Assembly

Fireplace Owner’s Manual

LTR50001006, Rev. E

www. ca l a m e b b q . co m

High Elevation Installation

Your  replace is approved for elevations up to 4,500 feet in the US and

Canada.

When installing this appliance at an elevation above 4,500 feet in the

US, it may be necessary to decrease the input rating by changing the

existing burner ori ce to a smaller size. Reduce the input by 4% for

each 1,000 feet above sea level, unless the heating value of the gas

has been reduced, in which case this general rule will not apply. To

identify the proper ori ce size, check with your local gas utility.

When installing this unit at an elevation above 4,500 feet in Canada

check with your local authorities. Consult the local gas utility for assis-

tance in determining the proper ori ce for your location.

Natural Gas Conversion

CAUTION: This service is to be completed only by an authorized gas

appliance installer. Do not attempt this conversion on your own as

there is risk of serious injury or death.

To The Authorized Gas Appliance Installer:

All Cal Flame  replaces are shipped from the factory equipped to burn

on liquid propane fuel. Enclosed with this kit is a natural gas conversion

kit for converting this unit to natural gas. To perform this conversion,

follow the directions below and to the local regulation standards in

your area.

Make sure unit is not in operation and is cool enough to perform 1.

this service. Shut off and disconnect propane fuel source at the

regulator end.

Carefully remove the storage cover, lava rocks and  re logs. Turn 2.

unit over to access hose connections underneath.

While holding the propane ori ce in place with a wrench, unscrew 3.

brass  tting on fuel inlet hose. Unscrew propane ori ce and re-

move.

Using the new brass natural gas ori ce re-install the parts in the 4.

same sequence. Turn the protective screen / air intake sleeve to al-

low a controlled amount of air ﬂ ow through the screen and into the

fuel supply tube. Flame should have good retention. For a proper