Installation manual
10
I/O M 700 provides eight programmable I/O 700 channels, used for either:
• Programmable Inputs
• Outputs max* 700 mA for magnets, power supply etc
Use the I/O M 700 as an input module, or use it to monitor, control, and/or supply
units such as alarm devices, magnets. It can also provide constant power supply to other
system modules such as Control and Repeter Panels etc. For details on assembling a
system and denitions of common system terms, refer to the Installation Manual.
* Used as an output module, I/O M 700 can provide max output 1400 mA, if two out-
puts are connected together.
5100077-01A
I/O M 700 H
Charger M provides power to the system through the Backbone Bus. It connects to
either a change-over module or directly to a power supply, supervises change-over
and connects the power supply units. By using dual Charger M modules, it is possible
to replace one Charger M module without powering down the system. For details on
assembling a system and denitions of common system terms, refer to the Installation
Manual.
5100062-01A
Charger M H
The Change Over M X can switch automatically between two power sources, mains
and emergency, with preference towards mains power if both sources are operational.
The Change Over M X is used to connect to the PSU module in a system, and is also
provided with one extra power supply outlet (which can be used for example to a
printer). This is a separate module without any contact with the backbone bus. For
details on assembling a system and denitions of common system terms, refer to the
Installation Manual.
5100066-01A
Change Over M X H
Relay M 8 provides eight programmable relay contacts. Each of these relay contacts pro-
vide a potential free change-over contact. Use Relay M 8 to control units such as sirens,
magnets, ashlight, alarms and ventilation fans. For details on assembling a system and
denitions of common system terms, refer to the Installation Manual.
5100081-01A
Relay M 8 H
Salwico Fire Detection System