Installation manual
15
Salwico Fire Detection System
Standard communication protocols
Standard communication protocols available for integrations with other systems
• NMEA 0183
• MODBUS RTU
• MODBUS TCP/IP
• ESPA 444
The Evolution Address Programmer is used to set the address in Salwico Evolution re
alarm detectors in a marine environment (Hard Customer Code 2). The detector is
attached to the programmer. The procedure to set or change the address takes only a
few seconds. The EV-AD2 requires two 9 V PP3 non-rechargeable alkaline batteries. The
programmer indicates when the battery is low.
5200123-00A
EV-AD 2 addressing tool
Salwico EV-P is an analogue addressable smoke detector with an optical chamber. It is
designed to give early warning for the presence of smoke in the supervised area. At the
same time the detector offers a high protection against unwanted alarms. Salwico EV-P
is equipped with OMNIVIEW 360° LED indicator giving a clear, full 360° visibility of the
red alarm indication. The detector can be placed in harsh environments if it is mounted
on a splash proof base. The technical detector address is set with a special program-
ming tool, valid addresses are 1-254. Salwico EV-P has a ne pitch net which improves
the response to smoke and also reduces the amount of dust etc. entering the detector.
Salwico EV-P is equipped with an output for remote indication.
040020
EV-P Analogue Addressable Optical Smoke Detector
Addressing Tool
Addressable Detectors
ST Interface M is used for interfacing “old Servoteknikk” loops into the new Salwico
systems. Perfect solution for retrotting elderly systems with newer central cabinet. This
Module can be used in combination with virtually any Salwico addressable central. One
such module is required per each addressable loop.
5100433-02A
ST Interface M
Interfaces