Installation manual
23
Salwico Fire Detection System
The HC100 A2 is a conventional heat detector for use with all Salwico Fire Alarm Sys-
tems. The detector is with its low prole and smooth design very suitable in locations
with high architectural requirements such as ofces, restaurants, hotel rooms and cabins.
The heat sensing element is of thermistor type with a short response time to changes
in the ambient temperature. Alarms are optically indicated until they are reset on the
central. The detector is environmentally adapted in aspects of the selection of material
and design. The detector is polarisation independent (unless the remote output is used)
which simplies the installation. The mesh is very easy to change and clean which simpli-
es maintenance.
038000
HC100 A2 Conventional Heat Detector (57°DegC)
The HC100 A2-IP67 is a conventional heat detector for use with all Salwico Fire Alarm
Systems. It is delivered complete with adapter and base. In this version of HC100 the
detector and adapter are moulded together and lled with a special moulding com-
pound that gives it high resistance against dampness and vibrations. The detector cannot
be separated from the adapter. The HC100 A2-IP67 is suitable for location in harsh en-
vironments. The heat sensing element is of thermistor type with a short response time
to changes in the ambient temperature. Alarms are optically indicated until they are
reset on the central. The detector is environmentally adapted in aspects of the selec-
tion of material and design. The detector is polarisation independent (unless the remote
output is used) which simplies the installation.
38005
HC100 A2 Conventional Heat Detector (57°DegC) IP67
The HC100 D is a conventional heat detector for use with all Salwico Fire Alarm Sys-
tems. The detector is with its low prole and smooth design very suitable in locations
with high architectural requirements such as ofces, restaurants, hotel rooms and cabins.
The heat sensing element is of thermistor type with a short response time to changes
in the ambient temperature. Alarms are optically indicated until they are reset on the
central. The detector is environmentally adapted in aspects of the selection of material
and design. The detector is polarisation independent (unless the remote output is used)
which simplies the installation. The mesh is very easy to change and clean which simpli-
es maintenance.
038020
HC/100 D Conventional Heat detector head (100°DegC)
The SWM-1KL 140 is a xed temperature heat detector, designed for use in damp
spaces. It contains a bimetallic thermostat, which closes its contacts at alarm tempera-
ture. The detector is also available in versions with lower alarm temperature (57, 80 and
100°C) and in an intrinsically safe version, SWM-1KL/IS, see separate datasheets.
037174
SWM-1KL/140, Conventional Heat Detector (140°DegC)