Installation manual
28
The ADAPTER AOHS-IS is an adapter for IP55 detector bases. Only detector AOHS-IS
can be connected to this adapter. The adapter can be used for Salwico addressable re
alarm systems CS3000, CS4000 and NSAC-1. The ADAPTER AOHS-IS has an IS-label
on the side. NB! The classication society might have additional installation requirements
than what is mentioned in this data sheet.
N1430
NS-ADAPT-IS2, Adaptor for IP-55 base with N11250
The 2IP55 is a base for all Salwico IP55 detector adapters. Together with the adapters it
is possible to install smoke, heat and ame detectors in harsh
environment with an ingress protection up to IP55. It can be used for both addressable
and conventional re alarm systems.
046950
NS-2IP55, Base plate with cable glands, IP-55
Salwico EV-SPB-BI is an Evolution addressable short circuit isolator in an adapter for
watertight bases. It is to be used as an interface for conventional and analogue address-
able re detectors. EV-SPB-BI is a watertight variant of
base EV-BI. With a conventional detector tted on the base adapter, the address of the
isolator will be displayed by the system upon re alarm. Removal
of the detector will also be detected and reported as a fault. The technical address is set
with a special programming tool. Valid addresses are 1-254.
5200098-00A
EV-SPB-BI Base Adapter with Short Circuit Isolator
AC-IR-3Fq Conventional Base is suitable for installation of AC-IR-3Fq Detector in a
harsh environment. The base plate provides ingress protection up to IP67, when lock
screws are used. This base provides a termination possibility, for detector set in conven-
tional mode.
Features
• IP65/IP67 Ingress protection
• Low current draw
• Suitable for installation in harsh environment
• Remote LED Option
5200235-00A
AC-IR-3Fq Conventional Base for AC-IR-3Fq detector
Salwico Fire Detection System