Installation manual

29
Salwico Fire Detection System
AC-IR-3Fq Addressable Base is suitable for installation of AC-IR-3Fq Detector in a harsh
environment. The base plate provides ingress protection up to IP67, when lock screws
are used. The base provides a termination possibility, for detector set in Addressable
mode. The address is set by an 8-way DIP-switch.
Features
• IP65/IP67 Ingress protection
• Low current draw
• Suitable for installation in harsh environment
5200237-00A
AC-IR-3Fq Addressable Base for AC-IR-3Fq detector
The EC-Base is a low prole base plate for smoke and heat detectors from Salwico EC
range of detectors. It is equipped with an integrated 470 Ohm serial resistor for installa-
tion of EC-type detectors. This detector base is made for use in dry and clean
spaces.
Features:
• Low prole design
• Compatible with all detectors from EC- range
• Tamper resistant feature
• Detector removal detection
• Remote LED Option
5200177-00A
EC-BASE Detector base for dry spaces IP22
The EC-Adapt is a connection adapter with an integrated 470Ohm serial resistor for
installation of EC-type detectors on the IP55 base NS-2IP55 (part no. 46900) or 2IP55
(part no. 46950). This adapter is used for connection of EC-type detectors to the con-
ventional re alarm system, in an IP55 environment.
5200178-00A
EC-ADAPT Detector adapt for wet spaces
Insert the canister into the smoke dispenser. Lock into place using the screw mecha-
nism. Place the cup over the detector and discharge spray (not more than 1 second)
with a slight upward movement. Repeat this action without removing the cup every 10
seconds for max 1 minute, until the detector is in alarm.
N1738
Smoke detector tester
Test equipment