Installation manual

30
The Salwico IR test lamp is used to perform function test on Salwico IR ame detector.
The extension rods packed in a nylon case makes it possible to easily test the detector
in all environments.
001156
IR Test lamp Incl.rod
The Salwico SOLO 461 is a cordless heat detector tester for the Salwico heat de-
tectors. The tester suits point type, rate of rise, xed temperature and combination
detectors up to 90°C. Under the control of a microprocessor, blown air is heated by
the element just before exiting the duct. This minimise the possibility of heat damage
the plastic of the detector. The tester is activated when an infra-red beam is broken by
the detector. For battery charging instruction and general information, see the manual
delivered in the box.
N1743
Cordless Heat detector tester kit (recommend)
The W8066 Ultraviolet (UV) test lamp is a portable, battery operated source of UV
radiation that is used for periodic testing of ultraviolet ame detectors.
The intrinsically safe device simulates a re by producing a beam of UV radiation with
the same wavelength as the response range of the UV detectors, enabling the opera-
tor to verify proper system operation without the need for an open ame. The physical
characteristics of the W8066 are comparable to a common ashlight, making it easier to
handle and operate than other test lamps. The test lamp typically actuates a UV detec-
tor at a distance of approximately 10 meters.
001150
UV Test lamp EEx ia II CT4
Salwico UV test lamp is used to perform function test on Salwico UV ame detectors.
Salwico UV test lamp is delivered complete with rechargeable batteries and a battery
charger.
001155
UV Test lamp Portable
Salwico Fire Detection System