Installation manual

43
Salwico Gas Detection System
The Control M Gas is a control panel with a 4.3” graphical colour display used to man-
age and supervise a gas alarm system either as a external control or repeater panel.
Control M Gas External can be mounted on any at surface or ush mounted, inde-
pendently from a gas alarm cabinet. Control M Gas External is equipped with commu-
nication buses for connecting to the system via BBE interface RS-485 or BBE interface
PB-485. Features: • A backlit 4.3” graphical colour display • Alarm buzzer
• LED status indicators • Backbone Bus Interface RS-485 • Backbone Bus Interface
PB-485 (Power Boost loop) • USB interface (for service & maintenance) • Two con-
gurable inputs • Three programmable outputs
5103001-00A
Control M Gas External
Because of its compact dimensions, the Epson LX-300+II are the ideal 9-pin printer for
applications where space is limited and also a low cost solution for measurement and
control systems. With auto switching USB, serial and parallel interfaces the LX-300+II
provide exible standalone connectivity.
5200306-00A
Serial Printer Epson LX300+II
Control/Repeater Panels
Log Printer
The Sensor Interface Cabinet is an interface unit for 1 to 8pcs of gas detectors. It is
intended for use with Salwico Gas Detection System and can interface with gas detec-
tors with a 4-20mA transmitter interface. The Salwico SIC is connected to the power
boost loop and will accommodate up to eight analogue inputs for gas detectors at the
local area instead of the main central. The advantage with this is that the cables will be
monitored for breaks and short circuits, it will also save lots of installation costs due to
shorter cables. The unit continuously monitors the gas detector for gas alarms, faults and
also checks the supply voltage of the detector interface.
Sensor Interface Cabinets
Power Boost Loop units & Gas Detectors
The Sensor Interface Cabinets are available in the following variants.
Sensor Interface Cabinet with 4 analogue inputs for detectors
Sensor Interface Cabinet with 8 analogue inputs for detectors
Sensor Interface Cabinet with 4 analogue inputs for detectors and 8 programmable dry
relay contacts
Sensor Interface Cabinet with 4 analogue inputs for detectors and 1 RS485 serial inter-
face
Sensor Interface Cabinet with 1 RS485 serial interface
Sensor Interface Cabinet with 8 programmable dry relay contacts
Sensor Interface Cabinet with 16 programmable dry relay contacts
For detailed information see datasheet.
SIC-1A
SIC-2A
SIC-1A1R
SIC-1A1C
SIC-1C
SIC-1R
SIC-2R