Installation manual

57
Salwico Monitoring System
The Salwico CO2 analyser provide continuous monitoring and control of gas con-
centration levels. It feature comprehensive output, alarm and fault indications via the
on-board microcontroller. Based on dual wavelength non-dispersive infra-red (NDIR)
technology, high performance operation with low maintenance requirements. The
operation of the CO2 analyser is described in terms of the outputs (display, LED indica-
tors, analogue output, alarm and fault relays), inputs (gas sensor, ow sensor, fault detec-
tion system) and the controls (setpoint controls, setpoint buttons, test button and the
options bitswitch).
550370
Guardian CO2 Analyser
The Oxygen Probe Model OM10 is based on an in-situ-monitoring of the oxygen con-
centration in the ow gas without sampling. The OM10 probe is a simple and compact
low price probe well suited for non demanding use with exhaust gas temperatures up
to 600 °C. As well as under the condition that the ow gas is neither wet, nor contains
too much tar, dust or airborne particles. The OM10 probe zirconium oxide sensor gives
a precision of 0.1 % with 2 % oxygen concentration in the exhaust gas. The maintenance
need is low due to the fact that the OM10 has no moving parts and that the zirconium
oxide cell has a long lifetime and is easy to replace.
550030
OM10 Zirconia O2 sensor
Electrical connections are established with the help of an AMP-connector. If a V/I trans-
mitter is desired, the AMP-connector is kept in a watertight and chock
absorbing container. (For OM10 Zirconia sensor, 550030)
550160
Stack unit (required if distance to probe is longer then 10m)
The Salwico DL256 data logger system is designed for modern data acquisition
applications. The system can handle both analogue and digital input and output signals
as well as serial communication with monitors and sensors. The hardware is based on
modules and is therefore easy to upgrade by adding modules.
550060
DL256 STD Logger 1 x DM016 & 2 x IM001