Specifications
LTR50001024, Rev. C
9
High Power Conguration for 5100DV and 6200 DV
Systems
To operate the spa in high power mode, ensure the following steps are
performed before starting your spa:
When installing the •
electrical system,
use a 50 amp GFCI.
Follow the GFCI
wiring diagram on
the next page.
Have your dealer •
or installer set dip
switch #10 to the
OFF position on
the circuit board as
shown below.
High Power Conguration for 6300DV System
The 6300DV control system requires higher power than other 240V sys-
tems. Dip switch #10 is factory set in the ON position. This causes the
heater to shut off when any pump is running in high speed. To allow the
heater to continue operating, dip switch #10 must be set to the OFF posi-
tion.
To ensure your spa functions properly, ensure the following steps are per-
formed before starting your spa:
When installing •
the electrical sys-
tem, use a 60 amp
GFCI. Follow the
GFCI wiring dia-
gram on the next
page.
Have your dealer •
or installer set dip
switch #10 to the
OFF position on
the circuit board
as shown below.