Owner`s manual

Owner’s Manual Page 29
Cleaning and Maintenance Owner’s Manual
Multi-Purpose Cleaner (Spa finish cleaning)
Cal Spas Multi-Purpose Cleaner is an essential part of maintaining your spas finish. Through normal use, the
spas finish can accumulate dirt, oil, and calcium causing a rough feel and unsightly scum lines. Cal Spas
Multi-Purpose Cleaner is a low detergent, non-abrasive cleaner specifically formulated to clean the spa without
damaging it acrylic finish. The most effective solution to minimize cleaning time is prevention. When the
following steps are followed, the spas’ finish will actually start to resist most of the elements that cause calcium
build-up and make scum line cleanup easier.
Prior to Spa Start-Up and Refilling
1. Spray Cal Spas Multi-Purpose Cleaner directly on to the spas finish.
2. Wipe clean with a clean soft clothe.
3. Repeat on heavily calcified areas.
4. Wipe spa thoroughly with a wet sponge, rinsing often with a bucket of clean water.
5. Allow spa to dry completely.
6. Apply a coat of Cal Spas Fast Sheen to the spas entire finish with a soft towel or sponge.
7. Allow Fast Sheen to dry until white and powdery.
8. Buff clean with a soft cloth, rotating frequently.
Periodic Maintenance
1. Spray Cal Spas Multi-Purpose Cleaner directly to the spas finish.
2. Wipe clean with a clean soft cloth.
3. Wipe spa thoroughly with a wet sponge, rinsing often in a bucket of clean water.
Use of Cal Spas Multi-Purpose Cleaner
Cal Spas Multi-Purpose Cleaner should not be sprayed directly into the spa water. Incorrect usage of this
product will cause water clarity issues.
Fast Sheen (Spa finish protecting wax)
Cal Spas Fast Sheen is an essential part of maintaining your spas finish. Through normal use, the spas finish can
accumulate dirt, oil, and calcium, causing a rough feel and unsightly scum lines. Cal Spas Fast Sheen is a
non-oil based wax that is specifically formulated to protect the spas finish from the chemicals and minerals
associated with normal spa use. The most effective solution to minimize cleaning time, is prevention. When the
following steps are followed, the spas finish will actually start to resist most of the elements that cause calcium
build-up and make scum line cleanup easier.
Prior to Spa Start-Up and Refilling
1. Spray Cal Spas Multi-Purpose Cleaner directly to the spas finish.
2. Wipe clean with a soft cloth.
3. Repeat on heavily calcified areas.
4. Wipe spa thoroughly with a wet sponge, rinsing often in a bucket of clean water.
5. Allow the spa to dry completely.
6. Apply a coat of Cal Spas Fast Sheen to the spas entire finish with a soft cloth or sponge.
7. Allow Fast Sheen to dry until white and powdery.
8. Buff clean with a soft cloth, rotating frequently.
IMPOR
TANT
: Cal Spas Fast Sheen should not be used on spas full of water. Only apply to a clean, cool,
dry surfaces. Incorrect product usage may cause water clarity issues.