Owner`s manual

Cal Spas Clear Water Plan
Prior to filling a spa for the first time, or after a routine draining, you will want to follow this start-up plan to
extend water life and performance. If you are following either bromine or chlorine Clear Water plans, you will
notice that both start-up processes are the same with the exception of Step 4. As with all chemical dosages
listed in the Clear Water Plan, start-up dosages are intended for 500 gallon spas. Please adjust the chemical
dosages to the capacity of your particular spa.
Start-Up
1. Clean spa thoroughly with Cal Spas Multi-Purpose Cleaner.
2. Apply a protective coat of Cal Spas Fast Sheen to the acrylic surface.
3. Fill spa to proper water level with normal tap water. (Do not use soft water.)
4. Bromine Plan: Add 2oz. of Cal Spas Go Brom to establish a bromine base level.
Chlorine Plan: Add two tablespoons of Cal Spas Granular Chlorine to the spa water.
5. Pour in 3oz. of Cal Spas Metal Protector to the center of the spa.
6. Sprinkle 2oz. of Cal Spas Oxidizer Shock in the center of the spa and leave spa uncovered and turn on the
jets for 30 minutes prior to recovering.
7. Allow 24 hours prior to testing and implementing the bromine or chlorine Clear Water Plans.
Cal Spas Clear Water Plan (Bromine)
Bromine Users
This plan and its chemical dosages are intended for Cal Spas chemicals only. Most chemical manufacturers use
different chemical formulas and strengths. Only Cal Spas chemicals are specially formulated to provide
chemical balance at lower dosages. Compare labels and dosages and see for yourself. You will get greater
protection and performance with Cal Spas chemicals.
Always read and follow all printed instructions on chemical bottles and packages.
Day One (Monday)
1. Test spa water using test strips. (Check for valid expiration date.)
2. Add two bromine tablets to floater. (Amount of tablets needed will vary with water temperature.)
3. Adjust Total Alkalinity, then the pH if needed. (See pH and Alkalinity sections for more information.)
4. Add 2oz. of Stan and Scale Defense.
5. Pull the dirty filter from the spa and place into liquid filter cleaner solution.
6. Place your extra, cleaned, fully dried filter cartridge in the spa.
7. Vacuum your spa with the Cal Spas Vac.
Day Two (Wednesday)
1. Test spa water using test strips. (Check for valid expiration date.)
2. Add two bromine tablets to floater. (Amount of tablets needed will vary with water temperature.)
3. Add 2oz. of Stan and Scale Defense.
Day Three (Friday)
1. Test spa water using test strips. (Check for valid expiration date.)
2. Check bromine floater for sufficient amount of bromine tablets. (Add one, if necessary.)
3. Adjust Total Alkalinity, then the pH if needed. (See pH and Alkalinity sections for more information.)
4. Add 1oz. of Oxidizer Shock.
Every Month
1. Check equipment area for leaks, rodents and insects.
Owner’s Manual Page 35
Owner’s Manual Cal Spas Clear Water Plan