Owner`s manual

Revised 01/01/04 Page

Temperature Adjustment (Range 80°F to 104°F)

The display screen will always display the actual water temperature. To display the temperature that the spa is

set to, simply depress the Temp pad. The set temperature will be flashing on the display panel. While the

display is flashing, each time you depress the Temp pad will change the set temperature either up or down by

one degree. Letting the display revert back to the actual water temperature, then depressing the Temp pad again

will allow you to change the direction of temperature adjustment.

Standard and Economy Modes

Your new spa is equipped with a Standard and Economy heating feature that gives you complete control of the

heating system.When the spa is powered up, it will automatically start in the Standard Heating Mode. In this

mode, the heating system will automatically activate whenever the water temperature drops more than one

degree below the set temperature. In the Economy Heating Mode”, the heating system will only activate during

filtration times. (See Setting Filtration Cycles page 31.)

To switch from the Standard Heating Mode to the Economy Heating Mode, simply depress the Temp pad

followed by the Light pad. Depress the same sequence to switch back to the Standard Heating Mode. Once in

the Economy Heating Mode,

Ec will be displayed in the center of the topside control panel and flash alternately

with the water temperature. This is to inform you of what heating mode you are currently in.

NOTE

: There is no topside control panel message displayed while in the “Standard Heating Mode”, only the

actual water temperature is displayed.

Initial Start up

When first powered up, the system will perform a self-diagnostic check and then it will automatically heat to,

and maintain a temperature of 100°F until you change the set temperature as listed in the “Temperature

Adjustment” section.

5000 ELECTRONIC OPERATION

Owner’s Manual 5000 Electronic Operation