Installation Sheet

Installation Instructions
ITEM NO. :
FX-3723-5P-BS FX-3723-5P-GM
1. Shut off main power at circuit breaker before attempting to
install this luminaire.
2. Screw the nipple into the center of the mounting plate (A),
leave enough length of the thread out of mounting plate for the
finial (D).
3. Install mounting plate (A) to junction box in ceiling using
mounting screws (B).
4. Pull the existing electrical wires out of the junction box and
make proper connections using wire nuts. Tighten the wire with
the nut screw (F) using a driver.
5. Position canopy (E) over mounting plate and align nipple (C)
to the center of the canopy (E) . With thread protruding through
the the center of the canopy (E), secure it with finial (D).
6. Screw the pole (F) to the body (G).
Turn on the main power and enjoy!
This LED light provides low maintenance service with no bulbs
to change.
INSTALLATION
** To ensure the success of the installation,be sure
to read these instructions and review the diagrams
thoroughly before beginning.
** Installation must be performed by a qualified
electrician.
** Turn off the main power at the circuit breaker
before installation,replacing lamp or maintenance.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
USE 7W x 5 MAX LED
Bulb (Included)
Cleaning & Care:
To clean, wipe the fixture with a soft, dry cloth. Avoid the use of harsh or abrasive chemicals as
they may damage the finish .
Suggested Dimmers
This fixture is designed to operate with most standard
dimmer.
Noted below is a listed of dimmers that have been
tested with this fixture. This list of dimmers does not
imply any guarantee or warranty of compatibility with a
particular application.
Dimmers that are not listed do not imply non-compatibility.
DVCL-153P / SCL-153P / AYCL-153P / CTCL-153P /
DVCL-253P / DVSCLL-253P / SELV-300P /
GT-150/GTJ-250M (ALL ARE LUTRON BRAND)
Wire nuts
(A) Mounting Plate
J-Box
(B) Screws
(C) Nipple
(G) Iron pipe
(D) Finial
(E) Canopy
(H) Body
(F) Nut Screw