Instructions / Assembly

ASSEMBLY INSTRUCTIONS
ITEM NO: FX-3810-1
CAREFULLY PLACE ALL PARTS ON A SMOOTH SURFACE AND
LAY THEM UP PER THE SKETCH BELOW.
SHUT OFF THE MAIN ELECTRICAL SUPPLY AT FUSE
BOX/CIRCUIT BREAKER.
1. SCREW CUP (G) TO LIGHT BODY (H), POLE (F) TO CUP (G).
2. AFFIX MOUNTING STRIP (A) TO JUNCTION BOX WITH
MOUNTING SCREW (B).
3. PUT THE WIRES THROUGH THE CANOPY (D)
AND MOUNTING STRIP (A) AND MAKE WIRE
CONNECTIONS:
CONNECT THE GREEN GROUND WIRE "〒" TO THE SUPPLY
WIRE, CATHODE WIRE "N" IN WHITE TO THE SUPPLY WIRE,
ANODE WIRE "L" IN BLACK TO THE SUPPLY WIRE IN
THE JUNCTION BOX AS ILLUSTRATED WITH WIRE NUTS.
4, LEAVE DESIRED LENGTH OF THE WIRE OUTSIDE THE
CANOPY AND FIX THE WIRE WITH THE PLASTIC RING
INSIDE THE CANOPY AND SET SCREW (E).
5. ATTACH THE CANOPY (D) TO THE MOUNTING STRIP (A)
AND TIGHTEN WITH SIDE SCREWS (C).
6. ALIGN SHADE (I) TO THE SOCKET OF LIGHT BODY (H)
AND TIGHTEN WITH SOCKET RING (J).
GLASS IS FRAGILE, TAKE WITH CARE!!!
7. INSTALL RECOMMENDED BULBS
(NOT INCLUDED IN THIS PACKAGE).
TURN OF POWER AND ENJOY!
TO REPLACE THE BULB:
TURN OFF POWER (UNPLUG FROM THE WALL OUTLET) BEFORE REPLACING THE BULB(S),
MAKING SURE THE BULB(S) HAVE SUFFICIENT TIME TO COOL DOWN.
DO NOT SUBJECT THIS FIXTURE TO ANY SHOCK WHILE LIT AS SHATTERING OF BULBS
MAY RESULT .
CARE INSTRUCTIONS:
TO CLEAN, USE A SOFT CLOTH ONLY. DO NOT USE ANY CHEMICAL OR ABRASIVE CLEANERS.
* THESE INSTRUCTIONS ARE PROVIDED FOR YOUR SAFETY
PURPOSE AND IT IS VERY IMPORTANT THAT THEY ARE READ
COMPLETELY BEFORE BEGINNING THE INSTALLATION OF YOUR
FIXTURE.
* DIRECT WIRE FIXTURES: WE STRONGLY RECOMMEND
INSTALLATION BY A LICENSED ELECTRICIAN.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Use Max 60W Type A
bulb (Bulb Not Included)
F
G
A
B
C
D
E
H
I
J