User's Manual

GETTING STARTED
001-9193-001 Version 2 Page 15 of 52 Sentry 4G
TM
User
Manual
4. GETTING STARTED
4.1 Package Contents
 Sentry 4G router
 Quick Start Guide
 Power cable
 User Manual and Quick Start Guide on CD
 Mounting Screws
4.2 Setup Requirements
 Sentry 4G router
 Computer running any operating system with a web browser installed such as Microsoft
Internet Explorer version 6.0 or later or Firefox version 2.0 or later.
 10-30V 5-A power supply
 Ethernet cable*
 Two antennas with male TNC connector*
 GPS Antenna (SMA Male) *
 Two WiFi Antennas (RP-SMA Plug) * ( if applicable)
 Two cellular (3G) antennas (SMA Plug) * (if applicable)
*These accessories are available from CalAmp.
4.3 Quick Start
4.3.1 Hardware Setup
Figure 3 – Sentry 4G router setup equipment
1. Connect the two Transmit/Receive antennas to the 4G MAIN and AUX TNC connectors on the
front of the unit. Connect the GPS antenna to the GPS connector. For units utilizing WiFi,
connect the WiFi antennas to the WiFi connectors. For units utilizing 3G, connect the 3G
antennas to the 3G connectors.
2. Connect an Ethernet cable from the ETH0 connector of the Sentry 4G unit to the PC. If
multiple PCs are being used, connect the Sentry 4G unit to an Ethernet switch or hub
connected to the PCs.
3. Connect a power supply cable to the PWR connector of the Sentry 4G unit. Do not power the
unit on yet.