User's Manual

CONFIGURATION
001-9193-001 Version 2 Page 24 of 52 Sentry 4G
TM
User
Manual
5.3.1.1 DNS Configuration
DNS servers can be configured as follows:
Mode:
Dynamic (Default): Obtain DNS IP addresses dynamically from a DHCP server.
Static: The DNS IP addresses are configured by the user.
DNS Server 1:
IP address of DNS server 1.
DNS Server 2:
IP address of DNS server 2.
5.3.1.2 NAT Configuration:
When NAT is enabled, the LAN interfaces (ETH0, ETH1, WLAN(Access Point)) are considered private,
the WWAN is considered public. Any IP packets leaving the Sentry 4G unit through the LAN interface
will have its source IP address changed to that of the WWAN interface.
Any data transfer must be initiated from the private side of the network toward the public side.
5.3.2 Channel Selection
Figure 9 – Sentry 4G WWAN Channel Selection
Maximum Tx Power: The maximum advertized power of the WWAN interface (Max 34.00).
Idle Timeout: The timeout before entering idle mode (Not Yet Implemented).
Channel Filter: The mask that defined the channels to use.