User's Manual

CONFIGURATION
001-9193-001 Version 2 Page 29 of 52 Sentry 4G
TM
User
Manual
IMPORTANT NOTE:
If the DHCP server is disabled, and you do not have a record of the Ethernet IP,
you will not be able to login to the Sentry 4G router home page.
On the network setting page of each PC set the following
– IP address: Set a unique address on the same subnet as the Sentry 4G
– Subnet Mask: Set to the same value as the Sentry 4G Ethernet Subnet Mask field
– Default Gateway: Ethernet IP of the Sentry 4G
– Preferred DNS: Ethernet IP of the Sentry 4G
When these settings are complete, the PC will have network access.
5.4.1.5 Static IP Setup
If your network requires each PC to have a statically set LAN IP addresses, follow the
previous procedure for all PCs on the network. If the network requires a mix of static and
dynamically assigned IP addresses, assign static IPs outside the DHCP address range for PCs
that require static IP addresses and allow the Sentry 4G DHCP to assign the remaining PC IP
addresses.
5.4.2 Statistics
This tab displays information regarding the number of packets and bytes transmitted and
received over the ETH0 or ETH1 interface.
5.5 WiFi (WLAN)
A Sentry 4G unit can simultaneously operate in an access point mode and in a client mode.