Operating Manual

© CalAmp Sentry 4G-900 pico Base Station 7 Getting Started
To set up the unit via the Quick Start pane
1. Click the Quick Start menu option. The Quick Start pane appears.
The following operation buttons are available:
Apply – implements changes performed by the user.
Reboot – reboot device and load SW from Preliminary bank
Stop Service / Start Service – two buttons used when service restart is required.
2. Update the required parameters in the Pane:
Base Station IP Address, Subnet Mask and Default GW (requires reboot).
Base Station Center Frequency (requires service restart)
Base Station Bandwidth – Values: 3.5MHz, 5MHz, 7MHz, 10MHz (default)
Authentication Mode:
o Null authentication – if this mode is selected, AAA Server parameters are not
relevant.
o PKMv2.0 – if this mode is selected, configure the AAA Server parameters
AAA Server IP Address, Server Port, Client ID and Client Secret (AAA User Defined
password)
3. Click Apply to save the changes. The parameters will not be uploaded to the Base Station
until the appropriate Restart or Reboot operation was performed.
4. Depending on the parameters that were modified, perform the relevant operation in order to
update the changes to the Base Station:
Restart the service (*) – click Stop Service and then Start Service
Reboot the Base Station (!) - click Reboot.
NOTE: (If necessary), to restore the factory defaults, click the Factory Default button.
Basic communication
parameters
(Corresponding to mode:
Standalone/ASN-GW)
Control options