Operating Manual

© CalAmp Sentry 4G-900 pico Base Station 10 Getting Started
Wireless – Access to all WiMAX parameters configuration
and diagnostics options.
Quick Start – Access to all parameters required for initial
set up of the system, depending on the operation mode
(Standalone / ASN-GW).
2.3.3 Modifying Parameters
Modified parameters are updated on the Base Station under three conditions, depending on the
parameter:
Some parameters do not require special operations - simply click Apply and they are
updated on the Base Station.
Some parameters affect the service – these are marked by an exclamation mark (!).
To update these parameters, click Stop Service and then Start Service (in the Quick Start
panel).
Some parameters are updated after performing system reboot - these are marked by an
asterisk (*).
For parameters that require reboot or service restart, two values are displayed:
The current value used by the Base Station.
The configured value - typed by the user but not yet updated onto the Base Station. (Will
be updated in the Base Station after the required restart/reboot operation).
See example below.