Operating Manual

© CalAmp Sentry 4G-900 pico Base Station 39 QoS Management
Max Rate [Kbits/sec]
Maximum rate for this SF. A value of „0‟ provides unlimited rate.
Max Latency [µsec]
(UGS, RT, eRT)
Relevant only for UGS, RT and eRT. A value of „0‟ does not put a limit on latency.
Maximum Latency (delay) for this SF. Set value according to the type of service
(i.e. <100ms for Voice and Video applications.
Unsolicited Grant [µsec]
Interval (UGS, eRT)
Relevant if the UGS – UGI - TBD
A value of „0‟ provides unlimited UGI.
Tolerated Jitter (UGS
only) [µsec]
the UGS tolerated jitter parameter…. A value of „0‟ does not put a limit on jitter.
Unsolicited Polling
Interval (RT, nRT)
[µsec]
The maximal nominal interval between successive polling grants opportunities for
this Service Flow, especially used for silence period of VoIP traffic with silence
suppression.
Has Classifiers
Read only. Displays whether or not this SF is assigned Traffic Classifiers.
Values: [True, False]
To configure the SF Classifiers see 5.2.2.2.
4. If required, define the Traffic classifiers according to the following section.
5. Reset the SS-Base Station connectivity:
Resetting the connection of a single SS (in case the SF is applied on a Registration
Base):
Click the Subscribers menu option. Choose the Subscriber Management sub-menu
and then the Registered SS.
In the displayed Registered SS Information pane select the radio button of the
requested SS and click the Deregister button.
Resetting the connection of all registered SSs (in case the SF is applied to All Users):
Click the Quick Start menu option.
In the displayed Quick Start pane click the Stop Service button, and then click the Start
Service button.
5.2.2.1 Bandwidth Latency and Jitter Guidelines