User Manual

A-2
001-2100-101
Power to the module is applied through the programming cable using the Red (B+) and Black
(ground) wires. Supply voltage is specified from +6.0VDC to +15 VDC. Nominal operating voltage is
+7.2 VDC or +12.5 VDC.
Dataradio recommends storing the programming software on the hard drive of the computer. When
the program is loaded, click on the “Read” button to read the unit’s current programming. Click on
“Parms” and select the appropriate tab (Settings, Radio or Frequencies) to make settings as required.
NOTE: If your application requires one frequency pair, Dataradio recommends all channel locations
be programmed with the same frequencies.