Synthesized TSLM Hi-Spec Integrated Wireless Modem
Synthesized TSLM Hi Spec Wireless Modem Installation Manual December 2005 001-2200-101 Revision 0 © 2005 by Dataradio COR Ltd. About Dataradio Dataradio is the leading designer and manufacturer of trusted wireless products and systems for critical infrastructure applications. Our products have been found at the heart of mobile and SCADA data networks around the world for over 20 years.
SECTION 1 GENERAL INFORMATION 1.1 INTRODUCTION 1.1.1 GENERAL This installation manual provides information for selecting, installing, operating, and maintaining the Dataradio TSLM wireless modem. 1.2 FEATURES The TSLM is a transparent real-time wireless modem designed primarily for SCADA (Supervisory Control and Data Acquisition) and telemetry use.
1.3 TSLM PART NUMBER BREAKDOWN The following table shows the breakdown of the TSLM part number. Table 1-1 TSLM Part Number Breakdown 242-22W0-XYZ W X Y 1 VHF 6 150-174 MHz 7 137-162 MHz 2 403-422 MHz 2 414-430 MHz 5 450-470 MHz 1 1 1 1 1 4 UHF Z 12.5 kHz 12.5 kHz 12.5 kHz 12.5 kHz 12.5 kHz 0 0 0 1 0 1.
Figure 1-3 Transceiver Identification Nomenclature 1.6 PRODUCT WARRANTY Dataradio warranties are available in Appendix B and are included in .pdf format on CD versions of Dataradio manuals. 1.7 FACTORY TECHNICAL SERVICE The Technical Service Department of Dataradio COR Ltd. (DRL) provides customer assistance on technical problems and serves as an interface with factory repair facilities. They can be reached by mail, phone, and email at: Dataradio COR Ltd.
www.dataradio.com/ products_tech_adv.html. Be prepared to give the equipment model and serial number, your account number (if known), and billing and shipping addresses. Include the RMA number, a complete description of the problem, and the name and phone number of a contact person with the returned units. This information is important. The technician may have questions that need to be answered to identify the problem and repair the equipment.
TSLM General Specifications The following general specifications are subject to change without notice. GENERAL VHF Frequency Channel bandwidth Operating temperature Supply voltage RX Current at 12.5 VDC TX Current at 12.5 VDC RX/TX bandwidth UHF 137 - 174 MHz 406.2 - 470 MHz 12.5 kHz 12.5 kHz -30°C to +60°C 6.00 – 15.0 VDC (applied through the interface connector) 180 mA 180 mA 2.0 A 2.
PROGRAMMABLE FEATURES 30 second timeout timer enable, bit rate, word length, parity, compatibility modes, frequency, channel, diagnostics on/off. FCC / IC CERTIFICATIONS FCC IC (DOC) VHF 2422210-001 (9K30F1D) 2984195430A (9K30F1D) (11K0F1D) UHF 2422240-001 (9K30F1D) 2984195432A (9K30F1D) (11K0F1D) SECTION 2 OPERATION AND CONNECTION 2.1 INTRODUCTION 2.1.1 GENERAL This section outlines the operation and connections of the TSLM. 2.2 FRONT PANEL 2.2.
Table 2-3 Modem DE15F Interface Connector Pin Outs Pin Name Pin Name Pin Name 1 Ground 6 Ground 11 CS 0 2 Rx Data 7 CTS 12 CS 1 3 Tx Data 8 RTS 13 CS 2 4 Test Audio 9 DCD 14 RSSI 5 B+ Power 10 B+ Power 15 DTR_PGM Note: Table 2-3 is for use with the 023-3276-007 (one end unterminated) if channel selection control is desired. If not, use 697-0000-001 cable. 2.3.3 INTERFACE SIGNAL DESCRIPTION Table 2-4 Signal Description B+ Power (input) 6.00 – 15.0 VDC (12.
2.4 CHANNEL SELECTION Channel frequencies for 8 channels are programmed using the TSLM Field Programming Software (FPS). Once programmed, the current operating channel may be selected either by: 1.Utilizing hardware jumpers By strapping connections on the Data Port Connector. There is a 10k ohm pull up resistor on each line (CS0 to CS2) (refer to Table 2-5) or making changes with the TSLM Field Programming Software: 2.By selecting the channel from the TSLM FPS Offline Diagnostics feature.
2.6 FCC MPE Compliance Reports - VHF and UHF RF Exposure Compliance Requirements TSLM VHF Wireless Modem FCC Rule: 1.1307, 1.1310, 2.1091 (b) (d), 2.1093 Description of Compliance: The TSLM will be professionally installed in the SCADA (Supervisory Control And Data Acquisition) market and will be mounted with a fixed RTU (Remote Terminal Unit). A typical installation would use a maximum gain antenna of 10 dBi mounted on a tower.
RF Exposure Compliance Requirements TSLM UHF Wireless Modem FCC Rule: 1.1307, 1.1310, 2.1091 (b) (d), 2.1093 Description of Compliance: The TSLM will be professionally installed in the SCADA (Supervisory Control And Data Acquisition) market and will be mounted with a fixed RTU (Remote Terminal Unit). A typical installation would use a maximum gain antenna of 10 dBi mounted on a tower.
2.6 IC MPE Compliance Reports - VHF and UHF RF Exposure Compliance Requirements TSLM VHF Wireless Modem IC Rule: RSS-119 Section 9, RSS-102 Section 4.2 Description of Compliance: The TSLM will be professionally installed in the SCADA (Supervisory Control And Data Acquisition) market and will be mounted with a fixed RTU (Remote Terminal Unit). A typical installation would use a maximum gain antenna of 10 dBi mounted on a tower. A minimum separation distance of more than 1.
RF Exposure Compliance Requirements TSLM UHF Wireless Modem IC Rule: RSS 119 Section 9, RSS-102 Section 4.2 Description of Compliance: The TSLM will be professionally installed in the SCADA (Supervisory Control And Data Acquisition) market and will be mounted with a fixed RTU (Remote Terminal Unit). A typical installation would use a maximum gain antenna of 10 dBi mounted on a tower. A minimum separation distance of more than 1.
