User's Manual

Integra-TR User Manual Page | 50
The Remote ID button allows the user to send diagnostic commands to any specific remote unit and obtain its diagnostic
information. The Remote ID is selected from the list of Remote IDs set up in the Diagnostic IDs and Alarms screen.
Diagnostic Select / Selected Remote ID
This button allows the user to gather Offline Diagnostics from the selected Remote ID only.
Diagnostic Select / Remote ID List
This button allows the user to gather Offline Diagnostics from all the IDs in the list of Remote IDs (including the local unit).
Get Diags
The Get Diags button allows the user to send the command for Offline Diagnostics. The command is sent to the unit
connected to the computer if the Local ID button is selected. The command is sent to the selected Remote ID if the Remote
ID and Selected Remote ID buttons are selected. The command is sent to the list of Remote IDs if the Remote ID and
Remote ID List buttons are selected.
Stop
The Stop button allows the user to stop any commands for Offline Diagnostics from being sent.
Save
The Save button allows the user to save the current Offline Diagnostics to a text file.
RSSI/Pwr
The RSSI/Pwr panel shows the current RSSI level (in dBm) while the local unit is receiving and the current Power Level (in
watts or dBm) while the local unit is transmitting.
Rev Pwr
The Rev Pwr check box allows the user to view the reverse power instead of forward power while the local unit is
transmitting.
F5
Pressing the F5 key will cause the unit to transmit on the programmed transmit frequency.
F6
Pressing the F6 key will cause the unit to go to receive on the programmed receive frequency.
Note: Commanding a remote unit to transmit will cause the unit to transmit on the programmed transmit frequency until
the Tx Timeout Timer expires. Be sure to program the Tx Timeout Timer in the Setup Modem/Radio Parameters Screen (see
Figure 16).
3.4.15 ONLINE DIAGNOSTICS