User Manual

Table Of Contents
120 20191-100a Paragon-III User Manual
22
4.7.2 Unit Status
Table 3 - Unit Status
Item Description
Banner
Displays Paragon-III information retrieved from the connected unit.
Have this information handy if contacting Dataradio support.
Station Name
Displays name of connected unit.
Configured under Setup Basic Î General Î StationID
Time Zone
Displays local time zone.
Configured under Setup Advanced Î SNTPÎ TimeZone
Local Time Displays local time computed using UTC time and Time Zone
Zulu Time
Displays UTC time.
Configured under Setup Advanced Î SNTPÎ SNTP UTC Time
4.7.2.1 Setup (General)
Table 4 - Setup (General)
Item Description
Station Name Station name identifier – Enter string up to forty characters in length
Connection mode Mobile/Base
IP Forwarding mode Router mode –
4.7.2.2 Basic IP Configuration
Table 5 - Basic IP Configuration
Item Description
IP Address Set to valid unique IP address for each individual unit
Network Mask
Set to valid IP netmask for each individual unit (may be same or differ-
ent depending on customer’s IP network topology)
.
IP Default Gateway
Set to valid Default Gateway.
May change for different groups or locations
4.7.2.3 RF Setup
Table 6 - RF Setup
Item Description
Power Level Sets power level between 0.1 and 1.0 watt (Default 1.0)
Airlink speed
256000, 512000 (Default) - Sets the maximum speed the HiPR900 will
use for data packet transmissions.
Slower speed preferred for longer
range.
SubBand Mask Indicates which channels are to be used in the shared band.
4.7.2.4 Terminal Server Configuration
Table 7 - Terminal Server Configuration
Item Description
Port 1 - 2400, 4800, 9600, 19200, 38400, 57600, 115200
Baud Rate
Port 2 - 2400, 4800, 9600, 19200, 38400, 57600, 115200
Port 1 - Inactive, TCP Passive, TCP Active, UDP
Connection Mode
Port 2 - Inactive, TCP Passive, TCP Active, UDP
Local IP Address
Valid unicast or multicast IP address, including the local Loopback
interface address.
Default local IP address is set to 0.0.0.0 and can be changed dynami-
cally without a unit reset.