User's Manual

120 20194-102 Paragon3 – 700/800MHz User Manual
24
4.7.2 Setup (Basic)
4.7.2.1 Setup (Basic) ► General
Used to set two basic operating fields on the connected unit.
Figure 22 - Setup (Basic) – General Setup
Item Description
Station Name Station name identifier – Enter string up to forty characters in length
System ID
Factory default ID is zero. To prevent collision and to minimize interference from re-
mote systems that may be present on the same frequency, Dataradio recommends
changing the System ID to some other value unique to each network.
Upper limit is 255
4.7.2.2 Setup (Basic) ► Basic IP Configuration
Sets the IP characteristics of the primary, or only, Ethernet port.
Figure 23 - Setup (Basic) – Basic IP Configuration
Item Description
Use fixed IP settings
Creates a fixed TCP/IP address connection. You may need to ask your network adminis-
trator for the appropriate IP settings.
ETH 1 IP Address
Set to valid unique IP address for each individual unit.
Factory default is 192.168.202.1 for all Paragon3 units connected to their ETH1 port.
For ETH2 configuration, see Setup Advanced Î LAN IP
ETH 1 Netmask
Set to valid IP netmask for each individual unit (may be same or different depending on
customer’s IP network topology).
Default Gateway
Set to valid Default Gateway.
May change for different groups or locations
Use DHCP Client Dynamic Host Configuration - Dynamically assigns an IP address
ETH 1 IP Address
ETH 1 Netmask
Default Gateway
These three read-only fields display the IP addresses obtained from the DHCP Server