User's Manual

120 20194-102 Paragon3 – 700/800MHz User Manual

5. Verify the integrity of the newly transferred files.

a) Connect to the base’s IP address using an Internet browser such as IE (5.0 or later) or Mozilla.

b) Enter the user name and password (in the usual manner) and allow the Welcome page to load.

c) In the left pane, click on Unit Status. The Unit Identification and Status pane should display the

newly upgraded firmware in its Banner (should correspond to the upgrade package version) and the

H/W Status should also show Ok.

d) In the left pane, click on Maintenance, then on Package Control. Wait a few moments for the results

to display. Figure 41 shows a “Pass” result indication.

Figure 47 – Sample FTP program

5.4.1.1 File Integrity Failure

If the message in the result screen points out that file(s) failed the integrity check, retry the FTP transfer for

the failed files(s) again.

If the problem persists, please have the Package Control result screen indications handy and contact Data-

radio system engineering for assistance.