User's Manual

001-2019-500 Rev 0 Paragon4 – UHF, 700 & 800MHz User Manual
20
6.3.3 IP Network Settings (Paragon4 connected directly to Host)
Figure 11 below illustrates Paragon4 base station settings. In Setup (Advanced) Î LAN (IP), set ETH1
and ETH2 IP addresses and netmask of both Base and Mobile(s).
Keep the RF IP setting as is, providing customer is not using the 10.0.0.0 IP network.
Add routes in the Host to reach the RF Network (route add…)
In the illustration, Host and PC are part of different IP subnet
Figure 11 - IP Network Settings in Router Mode (with Host)
6.3.4 IP Network Settings (Paragon4 connection to Router)
Figure 12 below illustrates Paragon4 base station settings. In Setup (Advanced) Î LAN (IP), set the
ETH1 and ETH2 IP addresses and netmask of both Base and Mobile(s).
In the illustration, Host and PC are part of different IP subnet.
Figure 12 - IP Network Settings in Router Mode (with Router)
On a PC running MS-Windows with an existing LAN connection, connect either to the ETH1 or to ETH2
RJ-45 input of the Paragon4 base station.

Paragon4 Base
SETUP:
Eth2 IP: 192.168.203.1
MASK: 255.255.255.0
RF IP: 10.0.0.1
MASK: 255.0.0.0
Mobile
DHCP Server
RF IP: 10.0.0.2
MASK: 255.0.0.0
Eth1 IP: 192.168.201.1
MASK: 255.255.255.0
RF Network
Host
IP: 192.168.202.2
MASK: 255.255.255.0
route add 10.0.0.0 mask 255.0.0.0 192.168.202.1
PC
DHCP Client
DATA:
Eth1 IP: 192.168.202.1
MASK: 255.255.255.0

Paragon4 Base
SETUP:
Eth2 IP: 192.168.203.1
MASK: 255.255.255.0
RF IP: 10.0.0.1
MASK: 255.0.0.0
Mobile
DHCP Server
NAT
RF IP: 10.0.0.2
MASK: 255.0.0.0
Eth1 IP: 192.168.201.1
MASK: 255.255.255.0
RF Network
Route
r
IP: 192.168.202.2
MASK: 255.255.255.0
route add 10.0.0.0 mask 255.0.0.0 192.168.202.1
PC
DHCP Client
DATA:
Eth1 IP: 192.168.202.1
MASK: 255.255.255.0
Default Gateway:
192.168.202.2
Host
Preliminary