User's Manual

001-2019-500 Rev 0 Paragon4 – UHF, 700 & 800MHz User Manual
31
6.7.2 Setup (Basic) ► IP (Basic IP Configuration)
Sets the IP characteristics of the primary, or only, Ethernet port (ETH1).
Figure 20 - Setup (Basic) – Basic IP Configuration
Item Description
Use fixed IP settings
Creates a fixed TCP/IP address connection. You may need to ask your network adminis-
trator for the appropriate IP settings.
IP Address
Set to valid unique IP address for each individual unit.
Factory default is 192.168.202.1 for all Paragon4 units connected to their ETH1 port.
For ETH2 configuration, see Setup Advanced Î LAN IP
Netmask
Set to valid IP netmask for each individual unit (may be same or different depending on
customer’s IP network topology).
Default Gateway
Set to valid Default Gateway.
May change for different groups or locations
Use DHCP Client Dynamic Host Configuration - Dynamically assigns an IP address
IP Address
Netmask
Default Gateway
These three read-only fields display the IP addresses obtained from the DHCP Server
For ETH2 configuration, see Setup Advanced Î LAN IP
Preliminary