User's Manual

—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit
pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
Class B digital device notice
“CAN ICES-3 (B)/NMB-3(B)”
RF Radiation Exposure Statement
This equipment complies with the FCC/IC radiation exposure limits set fourth for mobile transmitting
devices operation in an uncontrolled environment. End users must follow the specific operating
instructions to satisfy RF exposure compliance.
The equipment should only be used where there is normally at least 20cm separation between the
antenna and all person/user.
This transmitter must not be co-located or operation in conjunction with any other antenna or
transmitter, except in accordance with FCC/IC multi-transmitter RF Exposure procedures.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.