User's Manual
Table Of Contents
- LMU-3030 Hardware & Installation Guide
- [edit][top]1 Introduction
- 2 - System Overview
- 3 – Hardware Overview
- 3.1 Location messaging unit LMU-3030™
- 3.1.1 LMU-3030™ Handeling Precautions:
- 3.1.2 Battery backup devices
- Please properly dispose of the battery in any of the CalAmp products that utilize one, do not just throw used batteries, replaced batteries, or units containing a back-up battery into the trash. Consult your local waste management facility for proper ...
- 3.1.3 Environmental Specifications
- 3.1 LMU-3030™ connectors
- 3.2.1 Primary connector
- 3.2.2 Serial Adapter
- LMU Serial Cable (Part Number 133337)
- 3.3.1 Three-Axis accelerometer input
- the LMU-3030™ supports an internal 3 Axis Precision Accelerometer as one of its discreet inputs. When the LMU is moved in any direction, the associated input will be in the High state. If the LMU’s accelerometer does not detect motion, then the input ...
- 3.3.2 Status LEDs
- 4 – Configuration and activation
- You have contacted the CalAmp sales team regarding the network availability of the LMU-3030™. This device may not be supported for all the carriers or networks listed in this section (CDMA-Verizon, CDMA-Sprint, HSPA, GSM), for product availability c...
- 4.1 Quick Start – General config
- All LMU-3030s™ must go through a common step during the configuration and provisioning process. Specifically, this is pointing the LMU to your LM Direct™ server, either via IP or a URL.
- [edit][top]4.4 Accessing the SIM
- 6. Insert the SIM into the LMU.
- 7.
- 4.5 Activating a CDMA LMU-3030™
Please note that only 9 out of the 16 connector pins are actually populated on the connector.
Pin Signal Name Description
2 Bus+ Line SAE-J1850 PWM and SAE-1850 VPW
4 Chassis Ground Ground
5 Signal Ground Ground
6 Can High ISO 15765-4 and SAE-J2284
7 K line ISO 9141-2 and ISO 14230-4
10 Bus- Line SAE-J1850 PWM and SAE-1850 VPW
14 Can Low ISO 15765-4 and SAE-J2284
15 L line ISO 9141-2 and ISO 14230-4
16 Battery Power Power
