User's Manual
Table Of Contents
- LMU-3030 Hardware & Installation Guide
- [edit][top]1 Introduction
- 2 - System Overview
- 3 – Hardware Overview
- 3.1 Location messaging unit LMU-3030™
- 3.1.1 LMU-3030™ Handeling Precautions:
- 3.1.2 Battery backup devices
- Please properly dispose of the battery in any of the CalAmp products that utilize one, do not just throw used batteries, replaced batteries, or units containing a back-up battery into the trash. Consult your local waste management facility for proper ...
- 3.1.3 Environmental Specifications
- 3.1 LMU-3030™ connectors
- 3.2.1 Primary connector
- 3.2.2 Serial Adapter
- LMU Serial Cable (Part Number 133337)
- 3.3.1 Three-Axis accelerometer input
- the LMU-3030™ supports an internal 3 Axis Precision Accelerometer as one of its discreet inputs. When the LMU is moved in any direction, the associated input will be in the High state. If the LMU’s accelerometer does not detect motion, then the input ...
- 3.3.2 Status LEDs
- 4 – Configuration and activation
- You have contacted the CalAmp sales team regarding the network availability of the LMU-3030™. This device may not be supported for all the carriers or networks listed in this section (CDMA-Verizon, CDMA-Sprint, HSPA, GSM), for product availability c...
- 4.1 Quick Start – General config
- All LMU-3030s™ must go through a common step during the configuration and provisioning process. Specifically, this is pointing the LMU to your LM Direct™ server, either via IP or a URL.
- [edit][top]4.4 Accessing the SIM
- 6. Insert the SIM into the LMU.
- 7.
- 4.5 Activating a CDMA LMU-3030™
3.2.2 Serial Adapter
LMU Serial Cable (Part Number 133337)
This is the standard serial cable used with most LMU products.
LMU™ Serial Adapter
It only connects to the LMU-2000™ products thru an adapter (i.e. the 5C332).
Serial Cable Adapter (Part Number 5C332)
This accessory allows users to connect the standard LMU serial cable to the LMU-2000™.
3.2.3 Accessories
See the Harness Diagrams page for more information on LMU accessories, and supported products
table.
3.3 I/O Descriptions
The LMU-3030™ provides the following Inputs for scripting purposes, but there are no selectable
inputs on the device
Digital Inputs
Input 0: Ignition Sense
Input 1: Motion Sensor (low = no motion, high = motion)
Analog to Digital Inputs
A/D 0: Vin
A/D 1: uP Temp
A/D 2: Vref