User's Manual
Table Of Contents
- LMU-3030 Hardware & Installation Guide
- [edit][top]1 Introduction
- 2 - System Overview
- 3 – Hardware Overview
- 3.1 Location messaging unit LMU-3030™
- 3.1.1 LMU-3030™ Handeling Precautions:
- 3.1.2 Battery backup devices
- Please properly dispose of the battery in any of the CalAmp products that utilize one, do not just throw used batteries, replaced batteries, or units containing a back-up battery into the trash. Consult your local waste management facility for proper ...
- 3.1.3 Environmental Specifications
- 3.1 LMU-3030™ connectors
- 3.2.1 Primary connector
- 3.2.2 Serial Adapter
- LMU Serial Cable (Part Number 133337)
- 3.3.1 Three-Axis accelerometer input
- the LMU-3030™ supports an internal 3 Axis Precision Accelerometer as one of its discreet inputs. When the LMU is moved in any direction, the associated input will be in the High state. If the LMU’s accelerometer does not detect motion, then the input ...
- 3.3.2 Status LEDs
- 4 – Configuration and activation
- You have contacted the CalAmp sales team regarding the network availability of the LMU-3030™. This device may not be supported for all the carriers or networks listed in this section (CDMA-Verizon, CDMA-Sprint, HSPA, GSM), for product availability c...
- 4.1 Quick Start – General config
- All LMU-3030s™ must go through a common step during the configuration and provisioning process. Specifically, this is pointing the LMU to your LM Direct™ server, either via IP or a URL.
- [edit][top]4.4 Accessing the SIM
- 6. Insert the SIM into the LMU.
- 7.
- 4.5 Activating a CDMA LMU-3030™
The last item an operator may provide is a SIM PIN. The PIN is effectively a password to the device.
The main difference here is that the PIN will restrict all the capabilities of the GSM device, where the
SPC is used just for configuration.
The activation sequence for a GSM LMU would therefore look as follows:
AT$APP PARAM 2306,0,“myAPN.myOperator.com”
AT$APP PARAM 2306,1,“myAPN.myOperator.com”
AT$APP PARAM 2314,0,“myUSername”
AT$APP PARAM 2315,0,“myPassword”
For a blank APN the following command can be used:
AT$APP PARAM 2306,0,“” (for a blank APN)
Only enter this next command if you have been given a non-zero PIN as any errors may lock you out
of the modem.
AT$APP PIN <SIM pin>
You can confirm activation by watching the Comm LED to see if it goes solid. You may also confirm
activation using
AT$APP COMM STATUS?
A good response should look similar to the following:
GSM Registered: Yes
GPRS Registered: Yes
Connection: Yes
RSSI: -70 dBm
BER: 0
Channel: 0
Cell ID: 0
Base Station ID: 0
Local Area Code: 0
Network Code: 38
Country Code: 310
IMEI (Modem S/N): 500167110060440
IMSI (SIM S/N): 310380100521849