User's Manual
Table Of Contents
- LMU-3030 Hardware & Installation Guide
- [edit][top]1 Introduction
- 2 - System Overview
- 3 – Hardware Overview
- 3.1 Location messaging unit LMU-3030™
- 3.1.1 LMU-3030™ Handeling Precautions:
- 3.1.2 Battery backup devices
- Please properly dispose of the battery in any of the CalAmp products that utilize one, do not just throw used batteries, replaced batteries, or units containing a back-up battery into the trash. Consult your local waste management facility for proper ...
- 3.1.3 Environmental Specifications
- 3.1 LMU-3030™ connectors
- 3.2.1 Primary connector
- 3.2.2 Serial Adapter
- LMU Serial Cable (Part Number 133337)
- 3.3.1 Three-Axis accelerometer input
- the LMU-3030™ supports an internal 3 Axis Precision Accelerometer as one of its discreet inputs. When the LMU is moved in any direction, the associated input will be in the High state. If the LMU’s accelerometer does not detect motion, then the input ...
- 3.3.2 Status LEDs
- 4 – Configuration and activation
- You have contacted the CalAmp sales team regarding the network availability of the LMU-3030™. This device may not be supported for all the carriers or networks listed in this section (CDMA-Verizon, CDMA-Sprint, HSPA, GSM), for product availability c...
- 4.1 Quick Start – General config
- All LMU-3030s™ must go through a common step during the configuration and provisioning process. Specifically, this is pointing the LMU to your LM Direct™ server, either via IP or a URL.
- [edit][top]4.4 Accessing the SIM
- 6. Insert the SIM into the LMU.
- 7.
- 4.5 Activating a CDMA LMU-3030™
Keep in mind, however, this may cause the modem to lose its credentials and become unable to
register to the network.
4.5.2 Activating a CDMA LMU-3030™ – Sprint
Activating an LMU-3030™ on the Sprint CDMA network is identical to activating on the Verizon
network.
1. Power on the LMU-3030™, making sure you can observe the behavior of the Comm LED.
2. Wait until the Comm LED turns solid. This could take up to 5 minutes.
3. If after 5 minutes you observe that the Comm LED transitions from a slow blink to a fast blink
several times (i.e. more than twice) you will need to contact Sprint for further support on account
activation..
Once configured, you may verify that the LMU-3030’s™ modem has registered to the CDMA network.
Enter:
AT$APP COMM STATUS?
The response should be similar to:
CDMA Service: IS-2000
Connection: Yes
RSSI: -80 dBm
Channel: 0
Band:Side: 800:B
Base Station ID: 0
Network ID: 0
System ID: 4145
ESN (Modem S/N: 2676319948 [9F8566CC]
Phone Number: 1234567890
IMSI: 310001234567890
CarrierConfig: 1
The Phone Number field should match the <Phone Number> value you used in step 3 or 4. The last 10
digits of the IMSI field should match the <MSID> value you used in step 3 or 4.