User's Manual
Table Of Contents
- 1 Introduction
- 2 Description
- 3 Setup
- 3.1 LMU BT LE driver streams and serial port configuration parameters setup example.
- 3.2 LMU BTST SPP driver streams and serial port configuration parameters setup example.
- 3.3 LMU Bluetooth driver configuration parameters setup.
- 3.4 LMU user serial message configuration parameters setup example.
- 3.5 BTCS version format.
- 3.6 BTCS default Pass key.
- 3.7 Verification of LMU BTST SPP mode “Data” state example.
- 3.8 Verification of LMU configuration for BLE “connection” mode example.
- 3.9 Verification of LMU BLE “Advert broadcast scanning” mode configuration example.
- 4 Usage
- 4.1 Demonstration of LMU BT SPP mode.
- 4.2 Demonstration of BLE “connection” mode based remote temperature sensor device.
- 4.2.1 Send command “Enable notifications on Temperature sensor attribute profile”.
- 4.2.2 Send command “Start temperature conversion”.
- 4.2.3 Observe the GPSTRAX server User 0 temperature data.
- 4.2.4 Disable BLE sensor “notifications”.
- 4.2.5 Send command “Stop” temperature conversion.
- 4.2.6 “GPSTRAX” server report contains temperature sensor data.
- 4.3 Demonstration of BLE “broadcast scanning” mode based remote KeyFob DriverID device.
- 5 PWA Label
- 6 Integration Instructions
User Manual
Version:
1.0
Feature: Bluetooth Support
Page #:
11 of 20
4.2.5 Send command “Stop” temperature conversion.
Populate the data field in Figure 2 with the hexadecimal representation of ATGW,1,41,1,0 -
0x415447572C312C34312C312C30
4.2.6 “GPSTRAX” server report contains temperature sensor data.
10/22/2013
20:21:45
486100
0011
36.7
926
0 0 0A474154545F56414C2C312C303033372C312C34
2C43444646463430420D
4.3 Demonstration of BLE “broadcast scanning” mode based remote
KeyFob DriverID device.
The GPSTRAX server report will contain the following User0 messages:
0A444953434F564552592C322C3030303738303637434437322C302C2D35352C332C30323
03130362D3032304130332D3035303146464646353430310D
Which converted into ASCII representing “Button1 press” event:
DISCOVERY,2,00078067CD72,0,-55,3,020106-020A03-0501FFFF5401
The user payload content description is given in 3.3.
The Raw message type 4 is presented below:
830548610000110101000415A25295086652950866EA11DA4C682ABBA7000000000000000
000AE0B020001FFCD4F09DD000000003D0A444953434F564552592C322C30303037383036
37434437322C302C2D35352C332C3032303130362D3032304130332D30353031464646463
53430310D
5 PWA Label