User's Manual
Table Of Contents
- 1 Introduction
- 2 Description
- 3 Setup
- 3.1 LMU BT LE driver streams and serial port configuration parameters setup example.
- 3.2 LMU BTST SPP driver streams and serial port configuration parameters setup example.
- 3.3 LMU Bluetooth driver configuration parameters setup.
- 3.4 LMU user serial message configuration parameters setup example.
- 3.5 BTCS version format.
- 3.6 BTCS default Pass key.
- 3.7 Verification of LMU BTST SPP mode “Data” state example.
- 3.8 Verification of LMU configuration for BLE “connection” mode example.
- 3.9 Verification of LMU BLE “Advert broadcast scanning” mode configuration example.
- 4 Usage
- 4.1 Demonstration of LMU BT SPP mode.
- 4.2 Demonstration of BLE “connection” mode based remote temperature sensor device.
- 4.2.1 Send command “Enable notifications on Temperature sensor attribute profile”.
- 4.2.2 Send command “Start temperature conversion”.
- 4.2.3 Observe the GPSTRAX server User 0 temperature data.
- 4.2.4 Disable BLE sensor “notifications”.
- 4.2.5 Send command “Stop” temperature conversion.
- 4.2.6 “GPSTRAX” server report contains temperature sensor data.
- 4.3 Demonstration of BLE “broadcast scanning” mode based remote KeyFob DriverID device.
- 5 PWA Label
- 6 Integration Instructions
User Manual
Version:
1.0
Feature: Bluetooth Support
Page #:
19 of 20
9 Regulatory Information
Human Exposure Compliance Statement
Pursuant to 47 CFR § 24.52 of the FCC Rules and Regulations, personal communications
services (PCS) equipment is subject to the radio frequency radiation exposure requirements
specified in § 1.1307(b), § 2.1091 and § 2.1093, as appropriate.
CalAmp DataCom Inc. certifies that it has determined that the module complies with the RF hazard
requirements applicable to broadband PCS equipment operating under the authority of 47 CFR
Part 24, Subpart E of the FCC Rules and Regulations. This determination is dependent upon
installation, operation and use of the equipment in accordance with all instructions provided.
The module is designed for and intended to be used in fixed and mobile applications. “Fixed”
means that the device is physically secured at one location and is not able to be easily moved to
another location. “Mobile” means that the device is designed to be used in other than fixed
locations and generally in such a way that a separation distance of at least 20 cm is normally
maintained between the transmitter’s antenna and the body of the user or nearby persons. The
LMU-5000™ is not designed for or intended to be used in mobile applications (within 20 cm of the
body of the user) and such uses are strictly prohibited.
To ensure that the module complies with current FCC regulations limiting both maximum RF
output power and human exposure to radio frequency radiation, a separation distance of at least
20 cm must be maintained between the unit’s antenna and the body of the user and any nearby
persons at all times and in all applications and uses. Additionally, in mobile applications, maximum
antenna gain must not exceed 3.2 dBi.
FCC Rules and Industry Canada (IC) regulatory information
Compliance Statement (Part 15.19)
The equipment device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2) This device
must accept any interference received including interference that may cause undesired operation.
Warning (Part 15.21)
Changes or modifications not expressly approved by TransCore Amtech Systems could void the
user’s authority to operate the equipment. Manufacturer is not responsible for any radio or TV
interference caused by unauthorized modifications to this equipment.