User's Manual
Table Of Contents
- 1 Introduction
- 2 Description
- 3 Setup
- 3.1 LMU BT LE driver streams and serial port configuration parameters setup example.
- 3.2 LMU BTST SPP driver streams and serial port configuration parameters setup example.
- 3.3 LMU Bluetooth driver configuration parameters setup.
- 3.4 LMU user serial message configuration parameters setup example.
- 3.5 BTCS version format.
- 3.6 BTCS default Pass key.
- 3.7 Verification of LMU BTST SPP mode “Data” state example.
- 3.8 Verification of LMU configuration for BLE “connection” mode example.
- 3.9 Verification of LMU BLE “Advert broadcast scanning” mode configuration example.
- 4 Usage
- 4.1 Demonstration of LMU BT SPP mode.
- 4.2 Demonstration of BLE “connection” mode based remote temperature sensor device.
- 4.2.1 Send command “Enable notifications on Temperature sensor attribute profile”.
- 4.2.2 Send command “Start temperature conversion”.
- 4.2.3 Observe the GPSTRAX server User 0 temperature data.
- 4.2.4 Disable BLE sensor “notifications”.
- 4.2.5 Send command “Stop” temperature conversion.
- 4.2.6 “GPSTRAX” server report contains temperature sensor data.
- 4.3 Demonstration of BLE “broadcast scanning” mode based remote KeyFob DriverID device.
- 5 PWA Label
- 6 Integration Instructions
User Manual
Version:
1.0
Feature: Bluetooth Support
Page #:
20 of 20
Compliance Statement (Part 15.105(b))
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject
to the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne
doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
Class B digital device notice
“CAN ICES-3 (B)/NMB-3(B)”
RF Radiation Exposure Statement
This equipment complies with the FCC/IC radiation exposure limits set fourth for mobile
transmitting devices operation in an uncontrolled environment. End users must follow the specific
operating instructions to satisfy RF exposure compliance.
The equipment should only be used where there is normally at least 20cm separation between the
antenna and all person/user.
This transmitter must not be co-located or operation in conjunction with any other antenna or
transmitter.