Reference Guide Manual

 MATH CHAIn
 (Repeats options) MATH OrdEr
enTerinG dimensions
Linear Dimensions
When entering feet-inch values, enter dimen-
sions from largest to smallest — feet before
inches, inches before fractions. Enter fractions
by entering the numerator (top number),
pressing  (Fraction Bar key) and then the
denominator (bottom number).
Note: Ifadenominatorisnotentered,the
fractionalsettingvalueisused.
Examples of how linear dimensions are
entered (press  after each entry):
DIMENSIONS KEYSTROKES
5 feet  
5 feet, 1 ½ inches       
17.5 meters  7   
1250 millimeters      
Square and Cubic Dimensions
Examples of how square and cubic dimensions
are entered (press  after each entry):
DIMENSIONS KEYSTROKES
14 square inches    
11 square feet    
Po c k e t Re f e R e n c e Gu i d e — 17
4095 Inside_Corrected.indd 15 4/27/2009 8:42:57 AM