Troubleshooting guide

Setup Mode

Note: A Vantage Vue or Vantage Pro2 ISS or a Vantage Pro2 Anemometer Transmitter Kit must be

powered for the console to recognize it. Refer to the Integrated Sensor Suite Installation

Manual or other station manual for more information. It may take several minutes for the

console to acquire and display a transmitter ID after power is applied to both units.

1. Make a note of the station number(s) listed on the screen.

2. Press DONE to move to the next screen.

Screen 6: Configuring Transmitter IDs

Setup Screen 6 allows you to change the ISS

transmitter ID and to add or remove optional

transmitter stations.

The default transmitter ID setting is “1 VUE

ISS” (refers to a Vantage Vue ISS), which is

appropriate for most installations. If you are using only the Vantage Vue ISS with ID 1 press

DONE to move to the next screen.

Note: Typically, you can use the default transmitter ID setting of 1 unless a nearby neighbor has a

Vantage Pro2 or Vantage Vue station that uses transmitter ID 1.

If you wish to change this default transmitter ID:

1. Press the < and > keys to select a transmitter ID.

When you select a transmitter ID (1 - 8), the ID number is displayed on the screen as well

as its current configuration (OFF, VUE ISS, VP2 ISS or WIND).

2. Press the + or - keys to toggle console reception of signals from transmitters using that ID

on and off.

Note: Make sure any unused ID numbers are set to OFF.

To change the station type for the transmitter ID:

1. Press GRAPH to change the type of station assigned from VUE ISS to VP2 ISS or WIND.

• VUE ISS - Refers to the Vantage Vue ISS (whether direct transmission or retransmis-

sion from another console).

• VP2 ISS - Refers to the Vantage Pro2 ISS (whether direct transmission or retransmis-

sion from another console).

• WIND - Refers to an optional Anemometer Transmitter Kit (direct transmission only).

2. Press DONE to move to the next screen.

Note: This screen contains functionality for enabling repeaters. If the word “Repeater” displays in

the right corner of the screen and you are not using repeaters as part of your network, see

“Clearing Repeater ID” on page 51. If you are using repeaters as part of your network see

“Wireless Repeater Configuration” (Appendix C) on page 51.